A concept for a journal bearing with variable stiffness and damping properties is developed in order to decrease the vibration amplitude of a rotor-journal bearing system during passage through resonance. The introduction of an additional fluid film thickness in the bearing is proposed in this work in order to alter the dynamic properties in the bearing. The bearing ring is divided into two parts with the upper part being fixed with the housing and the lower part being flexibly mounted by a preloaded spring in parallel with a viscous damper. This allows relative motion between the two parts of the bearing ring. The relative motion introduces an additional fluid film zone in the bearing under the passive displacement of the lower part due to increased impedance forces that are developed in the lubricant film at resonance operation. The general concept is to change the system's damping and stiffness coefficients using this extra fluid film thickness only when the system passes through its critical speed in order to quench the vibration amplitude. For rotational speeds outside of the resonant regions, the bearing is considered to be fixed in order to behave as it was designed under the nominal loading operational conditions.
A Journal Bearing With Variable Geometry for the Reduction of the Maximum Amplitude During Passage Through Resonance
Contributed by the Design Engineering Division of ASME for publication in the Journal of Vibration and Acoustics. Manuscript received April 13, 2011; final manuscript received June 18, 2012; published online September 20, 2012. Assoc. Editor: Yukio Ishida.
Chasalevris, A., and Dohnal, F. (June 20, 2012). "A Journal Bearing With Variable Geometry for the Reduction of the Maximum Amplitude During Passage Through Resonance." ASME. J. Vib. Acoust. December 2012; 134(6): 061005. https://doi.org/10.1115/1.4007242
Download citation file: