Abstract
In this paper, the application scope of the average flow model is extended to grease lubrication considering the non-Newtonian characteristics. First, flow factor expressions applicable to both Newtonian fluids and non-Newtonian fluids are derived. Then, a model problem is established by coupling the Reynolds governing equation, film thickness function, and boundary conditions and solved for the flow factor. Fit the result into empirical relations for conveniently using in the grease lubrication analysis. Finally, the influence of several parameters on the flow factor is studied. The results demonstrate that the film thickness ratio, rheological index, and surface elastic deformation have a significant effect on the flow factor, and the influence law is affected by the orientation of the surface roughness.
Issue Section:
Hydrodynamic Lubrication
References
1.
Hamrock
, B. J.
, Schmid
, B. J.
, and Jacobson
, B. O.
, 2004
, Fundamentals of Fluid Film Lubrication
, CRC Press
, Boca Raton, FL
.2.
Zang
, L.
, Chen
, Y.
, Wu
, Y.
, Zheng
, Y.
, Chen
, H.
, You
, D.
, Li
, L.
, and Li
, J.
, 2020
, “Comparative Tribological and Friction Behaviors of Oil-Lubricated Manganese Phosphate Conversion Coatings With Different Crystal Sizes on Aisi 52100 Steel
,” Wear
, 458
, p. 203427
. 3.
Larsson
, R.
, 2009
, “Modelling the Effect of Surface Roughness on Lubrication in All Regimes
,” Tribol Int.
, 42
(4
), pp. 512
–516
. 4.
Kumar
, R.
, Azam
, M. S.
, and Ghosh
, S. K.
, 2019
, “Influence of Stochastic Roughness on Performance of a Rayleigh Step Bearing Operating Under Thermo-Elastohydrodynamic Lubrication Considering Shear Flow Factor
,” Tribol Int.
, 134
, pp. 264
–280
. 5.
Hu
, B.
, Zhou
, C. J.
, Wang
, H. B.
, and Chen
, S.
, 2021
, “Nonlinear Tribo-Dynamic Model and Experimental Verification of a Spur Gear Drive Under Loss-of-Lubrication Condition
,” Mech. Syst. Signal Process.
, 153
, p. 107509
. 6.
Allen
, Q.
, and Raeymaekers
, B.
, 2021
, “Soft EHL Simulations of Lubricant Film Thickness in Textured Hard-on-Soft Bearings Considering Different Cavitation Models, in the Context of Prosthetic Hip Implants
,” Tribol Lett.
, 69
(4
), p. 118
. 7.
Zhao
, J.
, Li
, Z. M. Q.
, Zhang
, H.
, and Zhu
, R. P.
, 2021
, “Effect of Micro-Textures on Lubrication Characteristics of Spur Gears Under 3D Line-Contact EHL Model
,” Ind. Lubr. Tribol.
, 73
(9
), pp. 1132
–1145
. 8.
Pusterhofer
, M.
, Bergmann
, P.
, Summer
, F.
, Grün
, F.
, and Brand
, C.
, 2018
, “A Novel Approach for Modeling Surface Effects in Hydrodynamic Lubrication
,” Lubricants
, 6
(1
), p. 27
. 9.
Zhang
, S. W.
, and Zhang
, C. H.
, 2021
, “A New Deterministic Model for Mixed Lubricated Point Contact With High Accuracy
,” ASME J. Tribol.
, 143
(10
), p. 102201
. 10.
Patir
, N.
, and Cheng
, H. S.
, 1978
, “An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic Lubrication
,” ASME J. Lubr. Technol.
, 100
(1
), pp. 12
–17
. 11.
Patir
, N.
, and Cheng
, H. S.
, 1979
, “Application of Average Flow Model to Lubrication Between Rough Sliding Surfaces
,” ASME J. Lubr. Technol.
, 101
(2
), pp. 220
–229
. 12.
Yang
, H. L.
, Li
, X. L.
, Sun
, W. W.
, Deng
, F.
, and Du
, J.
, 2021
, “Mixed EHL Numerical Analysis and Leakage Experiment of Skeleton Reciprocating Oil Seal
,” Ind. Lubr. Tribol.
, 73
(4
), pp. 660
–665
. 13.
König
, F.
, Sous
, C.
, and Jacobs
, G.
, 2021
, “Numerical Prediction of the Frictional Losses in Sliding Bearings During Start–Stop Operation
,” Friction
, 9
(3
), pp. 583
–597
. 14.
Xiang
, C.
, Guo
, F.
, Jia
, X. H.
, Wang
, Y. M.
, and Huang
, X.
, 2019
, “Thermo-Elastohydrodynamic Mixed-Lubrication Model for Reciprocating Rod Seals
,” Tribol. Int.
, 140
, p. 105894
. 15.
Bobach
, L.
, Beilicke
, R.
, and Bartel
, D.
, 2020
, “Transient Thermal Elastohydrodynamic Simulation of a Spiral Bevel Gear Pair With an Octoidal Tooth Profile Under Mixed Friction Conditions
,” Tribol. Int.
, 143
, p. 106020
. 16.
Kim
, T. W.
, and Cho
, Y. J.
, 2008
, “The Flow Factors Considering the Elastic Deformation for the Rough Surface With a Non-Gaussian Height Distribution
,” Tribol. Trans.
, 51
(2
), pp. 213
–220
. 17.
Wang
, Y. C.
, Liu
, Y.
, Wang
, Z. C.
, and Wang
, Y. M.
, 2017
, “Surface Roughness Characteristics Effects on Fluid Load Capability of Tilt Pad Thrust Bearings With Water Lubrication
,” Friction
, 5
(4
), pp. 392
–401
. 18.
Brenner
, G.
, Al-Zoubi
, A.
, Mukinovic
, M.
, Schwarze
, H.
, and Swoboda
, S.
, 2007
, “Numerical Simulation of Surface Roughness Effects in Laminar Lubrication Using the Lattice–Boltzmann Method
,” ASME J. Tribol.
, 129
(3
), pp. 603
–610
. 19.
Dobrica
, M. B.
, and Fillon
, M.
, 2009
, “About the Validity of Reynolds Equation and Inertia Effects in Textured Sliders of Infinite Width
,” Proc. Inst. Mech. Eng. Part J J. Eng. Tribol.
, 223
(1
), pp. 69
–78
. 20.
de Kraker
, A.
, van Ostayen
, R. A. J.
, and Rixen
, D. J.
, 2010
, “Development of a Texture Averaged Reynolds Equation
,” Tribol. Int.
, 43
(11
), pp. 2100
–2109
. 21.
Mubashshir
, M.
, and Shaukat
, A.
, 2019
, “The Role of Grease Composition and Rheology in Elastohydrodynamic Lubrication
,” Tribol. Lett.
, 67
(4
), p. 104
. 22.
De Laurentis
, N.
, Cann
, P.
, Lugt
, P. M.
, and Kadiric
, A.
, 2017
, “The Influence of Base Oil Properties on the Friction Behaviour of Lithium Greases in Rolling/Sliding Concentrated Contacts
,” Tribol. Lett.
, 65
(4
), p. 128
. 23.
Han
, Y. M.
, Wang
, J.
, Wang
, S. S.
, Zou
, Q.
, and Barber
, G.
, 2020
, “Response of Grease Film at Low Speeds Under Pure Rolling Reciprocating Motion
,” Friction
, 8
(1
), pp. 115
–135
. 24.
Wang
, D.
, Yang
, J.
, Wei
, P.
, and Pu
, W.
, 2021
, “A Mixed EHL Model of Grease Lubrication Considering Surface Roughness and the Study of Friction Behavior
,” Tribol. Int.
, 154
, p. 106710
. 25.
Zapletal
, T.
, Sperka
, P.
, Krupka
, I.
, and Hartl
, M.
, 2018
, “The Effect of Surface Roughness on Friction and Film Thickness in Transition From EHL to Mixed Lubrication
,” Tribol. Int.
, 128
, pp. 356
–364
. 26.
Ma
, F. B.
, Li
, Z. M.
, Qiu
, S. C.
, Wu
, B. J.
, and An
, Q.
, 2016
, “Transient Thermal Analysis of Grease-Lubricated Spherical Roller Bearings
,” Tribol. Int.
, 93
, pp. 115
–123
. 27.
Zhang
, K. F.
, Peng
, X. N.
, Zhang
, Y. Z.
, Zhou
, H.
, and Ma
, M.
, 2019
, “Numerical Thermal Analysis of Grease-Lubrication in Limited Line Contacts Considering Asperity Contact
,” Tribol. Int.
, 134
, pp. 372
–384
. 28.
Hua
, X. J.
, Puoza
, J. C.
, Zhang
, P. Y.
, Yin
, B. F.
, Xie
, X.
, and Din
, J. L.
, 2018
, “Numerical Simulation and Experimental Analysis of Grease Friction Properties on Textured Surface
,” Iran. J. Sci. Technol. Trans. Mech. Eng.
, 43
(2
), pp. 1
–13
. 29.
Patir
, N.
, 1978
, “A Numerical Procedure for Random Generation of Rough Surfaces
,” Wear
, 47
(2
), pp. 263
–277
. 30.
Kwak
, J. S.
, and Kim
, T. W.
, 2011
, “Contact Analysis for the Critical Shoulder Height in Angular Contact Ball Bearing
,” Tribol. Trans.
, 54
(5
), pp. 764
–769
. 31.
Love
, A. E. H.
, 1929
, “IX. The Stress Produced in a Semi-infinite Solid by Pressure on Part of the Boundary
,” Philos. Trans. R. Soc. A
, 228
(659–669
), pp. 377
–420
. 32.
Wen
, S. Z.
, and Huang
, P.
, 2017
, Principles of Tribology
, Tsinghua University Press
, Beijing
.33.
Dong
, D.
, and Qian
, X.
, 1988
, “A Theory of Elastohydrodynamic Grease-Lubricated Line Contact Based on a Refined Rheological Model
,” Tribol. Int.
, 21
(5
), pp. 261
–267
. 34.
Wen
, S. Z.
, and Yang
, P. R.
, 1992
, Elastohydrodynamic Lubrication
, Tsinghua University Press
, Beijing
.35.
Lugt
, P. M.
, 2012
, Grease Lubrication in Rolling Bearings
, John Wiley & Sons
, Hoboken, NJ
.36.
Kauzlarich
, J. J.
, and Greenwood
, J. A.
, 1972
, “Elastohydrodynamic Lubrication With Herschel–Bulkley Model Greases
,” Tribol. Trans.
, 15
(4
), pp. 269
–277
. 37.
Patir
, N.
, 1978
, Effects of Surface Roughness on Partial Film Lubrication Using an Average Flow Model Based on Numerical Simulation
, Northwestern University
, Evanston, IL
.38.
Huang
, P.
, 2013
, Numerical Calculation Methods of Elastohydrodynamic Lubrication
, Tsinghua University Press
, Beijing
.39.
Bordenet
, L.
, Dalmaz
, G.
, Chaomleffel
, J. P.
, and Vergne
, F.
, 1990
, “A Study of Grease Film Thicknesses in Elastorheodynamic Rolling Point Contacts
,” Lubr. Sci.
, 2
(4
), pp. 273
–284
. 40.
Pei
, J. X.
, Han
, X.
, Tao
, Y. R.
, and Feng
, S. Z.
, 2020
, “Mixed Elastohydrodynamic Lubrication Analysis of Line Contact With Non-Gaussian Surface Roughness
,” Tribol. Int.
, 151
, p. 106449
. 41.
Cen
, H.
, and Lugt
, P. M.
, 2019
, “Film Thickness in a Grease Lubricated Ball Bearing
,” Tribol. Int.
, 134
, pp. 26
–35
. Copyright © 2022 by ASME
You do not currently have access to this content.
