... strength and modulus of elasticity at room temperature and with the PCM fully melted within the composite are measured. Additionally, the hardness, latent heat of fusion, phase-change temperature, and thermal conductivity are investigated. An analysis of microstructures of the composite is used to support...

... to estimate the value of the state of the PV storage system from measurements of the PV generator voltage and current. The suggested technique is based on the quadratic Lyapunov function and does not employ a standard MPPT algorithm. Results show that the suggested control scheme has good tracking performance...

... is developed for the heat treatment of metal. This system includes an in situ waste heat recovery mechanism. This paper presents a Joule heating-based, controlled, experimental assessment of a laboratory-scale, retrofitted, SCF system for generating benchmark data. The reported measurements illustrate the heat...

... – 560 . 10.1016/0038-092X(88)90058-8 [3] Kumar , D. , Choudhury , R. , and Layek , A. , 2022 , “ Application of Liquid Crystal Thermography for Temperature Measurement of the Absorber Plate of Solar Air Heater ,” Mater. Today Proc. , 59 ( 1 ), pp. 605 – 611 . 10.1016/j.matpr...

... An orifice meter and a U-tube manometer are used to calculate the mass flowrate of air in the duct. The orifice meter is fixed between two galvanised iron pipes coaxially by using flanges. A micro-manometer is utilized to measure the pressure drop through the designed duct. Ethyl alcohol of 789 kg/m 3...

... of temperatures from 230 °C to 750 °C in concentrated solar thermal power systems. To conduct measurement of the heat transfer coefficient of the molten salt at high temperatures, a circulation system and instrumentation of flow and heat transfer was constructed. Experimental measurement of the convective heat...

... of this research was to perform the outdoor characterization of three PV technologies in a tropical climate and evaluate their performances with the aid of a set of key performance indicators. An innovative energy autonomous outdoor test facility has been used to measure the weather conditions and the IV curves...

... . 12 08 2021 04 01 2022 04 01 2022 02 03 2022 wind turbines blade design blade element momentum theory power coefficient tip speed ratio pitch angle Reynolds number clean energy environment measurement renewable Recently, renewable energy sources, especially...

.... Typical operating conditions are 29.2 °C water inlet temperature, 32.5 °C water outlet temperature, and 35.6 °C refrigerant condensing temperature. Water inlet and outlet temperatures are measured with thermistors in thermowells. The data are taken every 48 h for more than a 2500 h operating period in one...

... and PV output power in both (a) TSMC and (b) CSMC. Keeping the converter parameters same as mentioned in Table 1. Fig. 23 Approaching mode in TSMC parameters (Table 6 ) calculated using the cursor measurement feature of the scope Approaching mode in TSMC parameters (Table 6) calculated using...

... that the daily energy losses estimates ranged from 2.20 % up to 12.31 % in a period less than a month. efficiency energy measurement photovoltaics solar The soiling impact on PV plants in the Middle East North Africa region was studied in Ref. [ 16 ]. The authors performed a review of several...

... satellites dedicated to perform total solar irradiance (TSI) measurements and to build a record of their behavior over the years, thus making these data essential for meteorology and climatology. In this study, we propose a simplified model to understand the thermal behavior of absolute radiometers, which...

... C onservation . 06 02 2020 29 09 2020 29 09 2020 02 11 2020 absorber efficiency energy materials measurement optics photovoltaics renewable solar In recent years, solar cell technology has attracted much attention of many researchers. In fact...

... the soiling loss rates of PV modules for different tilt angles measured during a period of 15 months in the Western Region of Saudi Arabia. We observe a strong correlation between weather parameters like humidity and wind speed and the mechanism of dust accumulation. Our measurements show that, for specific...

... indigenously using ATMEL MEGA 2560 and ATMEL 328 microcontrollers. The parameters measured were PV panel surface temperature, inlet and outlet air temperatures, PV current, and voltage. The parameters were also compared with those of a reference PV system to demonstrate the effect of cooling of PV panel on its...

... evaluated. The highest amount of pressure drop through the collector was measured in the collector with a 70-mm bed height and a maximum air flowrate. Email: rahelehnowzari@aydin.edu.tr Email: hasansaygin@aydin.edu.tr Email: loayaldabbagh@uomosul.edu.iq Contributed by the Solar Energy...

... simulator's measurements. A sphere, cylindrical volume, cone, and multilayers of different shapes could also be employed to model the arc's emission of rays [ 23 ]. The distance between the cathode and anode electrodes in the lamp in this study was very short (9 mm). The arc was modeled as a sphere [ 5...

... heating mass transfer materials measurement radiation renewable solar solar cooker solar receiver sustainability testing thermal power thermodynamics Energy is the basic essential to satisfy the requirements of modern societies and to sustain the fast economic and industrial growth...

... efficiency energy environment heating measurement renewable simulation sustainability Renewable energy is a topic of interest due to global energy consumption growing at an alarming rate. Within the last 20 years, building energy consumption in developed countries has grown overall usage...

... uilding E nergy C onservation . 08 08 2019 11 11 2019 22 11 2019 17 12 2019 measurement photovoltaics radiation simulation solar Knowledge of the solar energy potential at a given site is an important parameter for designers of solar energy systems. Algeria...