Burr-free blanking requirements are strong; however, the thinner the product, the more difficult the burr-free blanking will be, due mainly to the control of the punch penetration depth. In this study, the principle of accompanying burr-free blanking problems, and the driving mechanism of methods for realizing burr-free blanking of foil were realized. The conditions for realizing successful burr-free blanking are the clearance of step 1 and punch penetration depth. Use of the piezoelectric actuator element and the design method for this was proposed as the punch drive mechanism. Good results were obtained by using this press machine for burr-free blanking of 50 μm copper foil.
Issue Section:
Technical Papers
Keywords:
blanking,
deburring,
punching,
sheet metal processing,
piezoelectric actuators,
foils,
copper
1.
Maeda
, T.
, 1954
, “Reciprocating Blanking Method
,” Science of Machine
, 10
(1
), pp. 140
–144
.2.
Liebing
, H.
, and Lange
, K.
, 1977
, “Blanking and Piercing Without Any Burr F
,” CIRP Ann.
, 27
, p. 177
177
.3.
Maeda
, T.
, and Aoki
, I.
, 1980
, “The Development of Burr-Free Blanking: Roll Blanking
,” J. Fac. Eng., Univ. Tokyo
, 25
(4
), pp. 754
–767
.4.
Makino
, I.
, 1975
, “Push Back Blanking Method
,” Press Working
, 13
(5
), pp. 93
–98
.5.
Aoki
, I.
, and Maeda
, T.
, 1991
, “Experimental Study on Process Mechanism of Burr-Free Blanking
,” J. Jpn. Soc. Technol. Plast.
, 32
(5
), pp. 621
–626
.6.
Oertenblad
, B.
, and Apppel.
, B.
, 1976
, “New Method for Cutting Hardened Carbon Steel
,” CIRP Ann.
, 25
, pp. 159
–163
.7.
Aoki
, I.
, Sasada
, M.
, Higuchi
, T.
, and Yano
, T.
, 2002
, “Development of Micro-Piercing System With Punch-Damage Monitoring Function
,” J. Mater. Process. Technol.
, 125
(126
), pp. 497
–502
.Copyright © 2004
by ASME
You do not currently have access to this content.
