A model based on the finite element method is presented for determining of thermal and mechanical stresses in a carbide insert due to heat and cutting forces induced during metal cutting with a brazed, clamped, and bonded carbide insert. Analysis revealed a high temperature gradient in the brazed insert, thus causing high thermal stresses. For the bonded insert a low temperature gradient but high temperatures were found, leading to possible tool edge chipping and a significant reduction of the bond layer strength. Finally local maxima of tensile and compressive stresses were identified on the rake face just after the chip had lost contact with the tool face. The estimated tensile stresses were close to the transverse rupture strength of sintered carbide. Shear stresses were at a maximum close to the tool edge at levels nearly equal to the shear flow strength of carbides. High compressive stresses can produce chipping at the tool tip.
Skip Nav Destination
Article navigation
November 1992
This article was originally published in
Journal of Engineering for Industry
Research Papers
Mechanical and Thermal Stresses in Clamped, Brazed, and Bonded Carbide Tools
M. A. Younis
M. A. Younis
Department of Mechanical Engineering, American University in Cairo, Egypt
Search for other works by this author on:
M. A. Younis
Department of Mechanical Engineering, American University in Cairo, Egypt
J. Eng. Ind. Nov 1992, 114(4): 377-385
Published Online: November 1, 1992
Article history
Received:
November 1, 1989
Online:
April 8, 2008
Article
Article discussed|
View article
Connected Content
Citation
Younis, M. A. (November 1, 1992). "Mechanical and Thermal Stresses in Clamped, Brazed, and Bonded Carbide Tools." ASME. J. Eng. Ind. November 1992; 114(4): 377–385. https://doi.org/10.1115/1.2900687
Download citation file:
24
Views
Get Email Alerts
Cited By
Related Articles
Chipping and Breakage of Carbide Tools
J. Eng. Ind (November,1978)
An Analysis of Thermal Cracking of Carbide Tools in Intermittent Cutting
J. Eng. Ind (May,1979)
Related Proceedings Papers
Related Chapters
Fatigue Analysis in the Connecting Rod of MF285 Tractor by Finite Element Method
International Conference on Advanced Computer Theory and Engineering, 4th (ICACTE 2011)
Subsection NB—Class 1 Components
Companion Guide to the ASME Boiler & Pressure Vessel Codes, Volume 1 Sixth Edition
On the Evaluation of Thermal and Mechanical Factors in Low-Speed Sliding
Tribology of Mechanical Systems: A Guide to Present and Future Technologies