In this paper, the experimental flow boiling heat transfer results of a minichannel are presented. A series of experiments was conducted to measure the heat transfer coefficients in a minichannel made of stainless steel (AISI 316) having an internal diameter of 1.70 mm and a uniformly heated length of 220 mm. R134a was used as a working fluid, and experiments were performed at two different system pressures corresponding to saturation temperatures of and . Mass flux was varied from to , and heat flux ranged from to . The test section was heated directly using a dc power supply. The direct heating of the channel ensured uniform heating, which was continued until dryout was reached. The experimental results show that the heat transfer coefficient increases with imposed wall heat flux, while mass flux and vapor quality have no considerable effect. Increasing the system pressure slightly enhances the heat transfer coefficient. The heat transfer coefficient is reduced as dryout is reached. It is observed that the dryout phenomenon is accompanied with fluctuations and a larger standard deviation in outer wall temperatures.
Flow Boiling Heat Transfer Characteristics of a Minichannel up to Dryout Condition
- Views Icon Views
- Share Icon Share
- Search Site
Ali, R., Palm, B., and Maqbool, M. H. (April 26, 2011). "Flow Boiling Heat Transfer Characteristics of a Minichannel up to Dryout Condition." ASME. J. Heat Transfer. August 2011; 133(8): 081501. https://doi.org/10.1115/1.4003669
Download citation file: