The effect of electric fields applied to two-phase impingement heat transfer is explored for the first time. The electric field applied between a capillary tube and heated surface enhances the heat transfer by controlling the free boundary flow modes from discreet drops to jets, to sprays. Through an experimental study, the impingement heat transfer was evaluated over a range of operating conditions and geometrical parameters with subcooled ethanol used as the working fluid. The ability to change the mode of impinging mass did change the surface heat transfer. The characteristics of the impinging mass on heat transfer were dependent on flow rate, applied voltage, capillary tube to heated surface spacing, capillary tube geometry, heat flux, heater surface geometry, and capillary tube array configuration. Enhancement occurred primarily at low heat fluxes (below $30W∕cm2$) under ramified spray conditions where the droplet momentum promoted thin films on the heated surface resulting in 1.7 times enhancement under certain conditions. Higher heat fluxes resulted in greater vapor momentum from the surface, minimizing the effect of different impingement modes. The use of capillary tube array allowed for electrohydrodynamics atomization enhancement and higher liquid flow rates, but electrostatic repulsive forces diverted the spray from the heater surface. This reduced the mass flux to the surface, leading to premature dryout under certain conditions.

1.
Webb
,
R. L.
, 2005, “
Next Generation Devices for Electronic Cooling With Heat Rejection to Air
,”
ASME J. Heat Transfer
0022-1481,
127
(
1
), pp.
2
10
.
2.
Mudawar
,
I.
, 2001, “
Assessment of High-Heat-Flux Thermal Management Schemes
,”
IEEE Trans. Compon. Packag. Technol.
1521-3331,
24
(
2
), pp.
22
141
.
3.
Cho
,
C.
, and
Wu
,
K.
, 1988, “
Comparison of Burnout Characteristics in Jet Impingement Cooling and Spray Cooling
,”
Proceedings of National Heat Transfer Conference
,
Houston TX
, pp.
561
567
.
4.
Estes
,
K.
, and
Mudawar
,
I.
, 1995, “
Comparison of Two-Phase Electronic Cooling Using Free Jets and Spray
,”
ASME J. Electron. Packag.
1043-7398,
117
, pp.
323
332
.
5.
Fabbri
,
M.
,
Jiang
,
S.
, and
Dhir
,
V. K.
, 2005, “
A Comparative Study of Cooling of High Power Density Electronics Using Spray and Microjets
,”
ASME J. Heat Transfer
0022-1481,
127
, pp.
38
48
.
6.
Zeleny
,
J.
, 1917, “
Instability of Electrified Liquid Surfaces
,”
Phys. Rev.
0031-899X,
10
, pp.
1
6
.
7.
Taylor
,
G. A.
, 1964, “
Disintegration of Water Drops in an Electric Field
,”
Proc. R. Soc. London, Ser. A
1364-5021,
280
, pp.
383
397
.
8.
Cloupeau
,
M.
, and
Prunet-Foch
,
B.
, 1994, “
Recipes Electrohydrodynamic Spraying Functioning Modes: A Critical Review
,”
J. Aerosol Sci.
0021-8502,
25
(
6
), pp.
1021
1036
.
9.
Grace
,
J. M.
, and
Marijnissen
,
J. C. M.
, 1994, “
A Review of Liquid Atomization by Electrical Means
,”
J. Aerosol Sci.
0021-8502,
25
(
6
), pp.
1005
1019
.
10.
Jaworek
,
A.
, and
Krupa
,
A.
, 1999, “
Classification of the Modes of EHD Spraying
,”
J. Aerosol Sci.
0021-8502,
30
(
7
), pp.
873
893
.
11.
Jones
,
T. B.
, 1978, “
Electrohydrodynamically Enhanced Heat Transfer in Liquids—A Review
,”
0065-2717,
14
, pp.
107
148
.
12.
Chang
,
J.
,
Kelly
,
A.
, and
Crowley
,
J.
, 1995,
Handbook of Electrostatic Processes
,
CRC
,
Boca Raton, FL
.
13.
1998,
Electrohydrodynamics
,
A.
Castellanos
, ed.,
Springer Wien
,
New York
.
14.
Seyed-Yagoobi
,
J.
, and
Bryan
,
J. E.
, 1999, “
Enhancement of Heat Transfer and Mass Transport in Single-Phase and Two-Phase Flows with Electrohydrodynamics
,”
0065-2717,
33
, pp.
95
180
.
15.
Watanabe
,
H.
,
Matsuyama
,
T.
, and
Yamamoto
,
H.
, 2003, “
Experimental Study on Electrostatic Atomization of Highly Viscous Liquids
,”
J. Electrost.
0304-3886,
57
(
2
), pp.
183
197
.