This experimental study was performed on a single row of round holes with a 35° surface angle, representing film cooling geometry commonly used in turbine engines. Simultaneous velocity and temperature measurements were made using a cold-wire in conjunction with a LDV. The experimentally determined cross correlations provide a direct indication of the extent of turbulent transport of heat and momentum in the flow, which in turn governs dispersion of the film cooling jet. Actual engine environments have elevated mainstream turbulence levels that can severely reduce the cooling capability of film cooling jets. Clearly, the turbulent transport for very high mainstream turbulence is expected to be markedly different than that with low mainstream turbulence, and would improve our understanding of the mechanisms involved in the dispersion of film cooling jets. Experimental cross-correlation data was obtained for two vastly different freestream turbulence levels (0.6% and 20%) in this study. For this purpose, eddy diffusivities for momentum and heat transport were estimated from the measured data. These results will help develop new turbulence models and also explain why gradient diffusion based models do not give good predictions relative to experimental results.

1.
Walters
,
D. K.
, and
Leylek
,
J. H.
,
1997
, “
A Systematic Computational Methodology Applied to a Three-Dimensional Film-Cooling Flowfield
,”
ASME J. Turbomach.
,
119
, pp.
777
785
.
2.
Andreopoulos
,
J.
, and
Rodi
,
W.
,
1984
, “
Experimental Investigation of Jets in a Crossflow
,”
J. Fluid Mech.
,
138
, pp.
93
127
.
3.
Pietrzyk, J. R., 1989, “Experimental Study of the Interaction of Dense Jets With a Crossflow for Gas Turbine Applications,” Ph.D. thesis, The University of Texas at Austin, Austin, TX.
4.
Kaszeta
,
R. W.
, and
Simon
,
T. W.
,
1999
, “
Measurement of Eddy Diffusivity of Momentum in Film Cooling Flows With Streamwise Injection,” ASME paper No. 99-GT-37.
5.
Kohli
,
A.
, and
Bogard
,
D. G.
,
1998
, “
Fluctuating Thermal Field in the Near Hole Region for Film Cooling Flows
,”
ASME J. Turbomach.
,
120
, pp.
86
91
.
6.
Kohli
,
A.
, and
Bogard
,
D. G.
,
1998
, “
Effects of Very High Freestream Turbulence on the Jet-Mainstream Interaction in a Film Cooling Flow
,”
ASME J. Turbomach.
,
120
, pp.
785
790
.
7.
Kohli, A., 1996, “Experimental Investigation of the Jet-Mainstream Interaction in Film Cooling Flow With Different Freestream Condition,” Ph.D. thesis, The University of Texas at Austin, Austin, TX.
8.
Thole
,
K. A.
,
Bogard
,
D. G.
, and
Whan-Tong
,
J. L.
,
1994
, “
Generating High Freestream Turbulence Levels
,”
Exp. Fluids
,
17
, pp.
374
380
.
9.
Thole, K. A., Sinha, A. K., Bogard, D. G., and Crawford, M. E., 1992, “Mean Temperature Measurements of Jets With a Crossflow for Gas Turbine Film Cooling Application,” Rotating Machinery Transport Phenomena, J. H. Kim and W. J. Yang, eds., Hemisphere Publishing Corp., New York.
10.
Chapra, S. C., and Canale, R. P., 1988, Numerical Methods for Engineers, 2nd ed., McGraw-Hill, New York.
11.
Thole, K. A., 1992, “High Freestream Turbulence Effects on the Transport of Heat and Momentum,” Ph.D. thesis, The University of Texas at Austin, Austin, TX.
12.
Thole
,
K. A.
, and
Bogard
,
D. G.
,
1994
, “
Simultaneous Temperature and Velocity Measurements
,”
Meas. Sci. Technol.
,
5
, pp.
435
439
.
13.
Chen
,
C. P.
, and
Blackwelder
,
R. F.
,
1978
, “
Large-Scale Motion in a Turbulent Boundary Layer: A Study Using Temperature Contamination
,”
J. Fluid Mech.
,
89, Part 1
, pp.
1
31
.
14.
Subramanian
,
C. S.
, and
Antonia
,
R. A.
,
1981
, “
Effect of Reynolds Number on a Slightly Heated Turbulent Boundary Layer
,”
Int. J. Heat Mass Transfer
,
24
, No.
11
, pp.
1833
1846
.
15.
Perry
,
A. E.
, and
Hoffman
,
P. H.
,
1976
, “
An Experimental Study of Turbulent Convective Heat Transfer From a Flat Plate
,”
J. Fluid Mech.
,
77, Part 2
, pp.
355
368
.
16.
Pope, S. B., 2000, Turbulent Flows, Cambridge University Press, Cambridge, UK.
You do not currently have access to this content.