... damping and tolerance to minor shaft misalignment and external shocks. In addition, the low viscosity of air or gas allows very low power consumption even at high speeds. A turbine simulator mimicking 50 kW power generation gas turbine was designed. The turbine simulator can generate the same...

... of the flow and an apparent increase in mixture viscosity, produce a hump in power loss. Cross-coupled stiffnesses and direct damping coefficients decrease steadily with increases in the gas volume fraction; however, some anomalies are apparent when the flow turns laminar. Mixture lubricated seals show...

... deposition, packing blockage, corrosion, and certain environmental impacts from salt drift and blowdown return. In addition, the salinity of seawater affects the thermophysical properties that govern the thermal performance of cooling towers, including vapor pressure, density, specific heat, viscosity...

... properties were suggested. In general, longer ignition delays were observed for component fuels with lower liquid fuel density, kinematic viscosity, and liquid-air surface tension. Longer ignition delay was also observed for component fuels with higher fuel volatility, as measured by boiling point and vapor...

... is possible for wide ranges of temperature from 243 K up to 2000 K, total pressure from 0.611 kPa up to 100 MPa, and water content up to 10% mass fraction with some restrictions concerning the calculation of viscosity η and thermal conductivity λ (up to 1000 K for both and up to 40 MPa for λ ). These models...

... liner engine was able to resolve changes in friction characteristics coinciding with changes in lubricant viscosity and temperature. The axial force increases at TDC and BDC were observed as lubricant viscosity was decreased and larger amounts of mixed and boundary lubrication began to occur. For each...

... to consider the effects of finite length-to-diameter ratios. This is achieved by means of a finite volume integration of the two-dimensional, Newtonian, compressible Reynolds equation combined with the effective mixture density and viscosity defined in the work of Diaz and San Andrés. A flow balance...

... feedstock. In this study, two types of biodiesels and vegetable oil (VO) are investigated as potential fuels for gas turbines to generate power. Biodiesels produced from VO and animal fat were considered in this study. The problems of high viscosity and poor volatility of VO (soybean oil) were addressed...

...Gabor Hazi; Istvan Farkas Studying heat transfer problems of supercritical water, the pressure dependency of thermophysical parameters (density, specific heat, viscosity, and thermal conductivity) and the work done by pressure are often neglected. Here we show that the variations of some physical...

... for Complex Turbulent Flows,” J. Fluid Mech., 254, pp. 59–78 ) and the cubic model of Lien et al. (1996, “Low Reynolds Number Eddy-Viscosity Modeling Based on Non-Linear Stress-Strain/Vorticity Relations,” Proceedings of Third Symposium on Engineering Turbulence Modeling and Measurements, Crete, Greece...

... of the simplicity of the design offered by a viscous flow turbine. 24 01 2007 24 04 2008 12 06 2008 boundary layers rotors turbines viscosity Brayton cycle scaling law expansion efficiency viscous flow turbine power MEMS It is well known that the principles used...

... with temperature, and heat loss from the cylinder. The results are presented for skirt friction only, and then for total piston friction (skirt and rings). The effect of oil viscosity is investigated over a wide range of engine speeds and oil temperatures. In general, it is found that oils with higher viscosities...

... of the test rotor imbalance by using the actual vibration measurements and influence coefficients derived from predictions using linearized bearing force coefficients. Predicted ring rotational speeds, operating radial clearances, and lubricant viscosities for the inner and outer films are the main input...

...Yasuo Harigaya; Michiyoshi Suzuki; Fujio Toda; Masaaki Takiguchi The effect of lubricant viscosity on the temperature and thickness of oil film on a piston ring in a diesel engine was analyzed by using unsteady state thermohydrodynamic lubrication analysis, i.e., Reynolds equation and an unsteady...

... that the prediction of the turbulence length scales in the Lombardini engine is improved with the employed dissipation correction. The turbulence viscosity, ν t , for the CAT and the S20, computed with and without the ε correction, are shown in Fig. 4 . Both engines show the same behavior...

... dissipation. The mean oil film temperature was determined from the calculation of the temperature distribution in the oil field which was calculated using the energy equation. The oil film viscosity was then estimated using the mean oil film temperature. The effect of oil film temperature on the oil film...

.... It is argued that solving the differential transport equations for each turbulent stress tensor component, as implied by second-moment closures, can better reproduce stress anisotropy and effects of rotation, than with eddy-viscosity models. Therefore, a Reynolds stress model that can meet the demands...