An analytical model of the cavitation process in a pump is developed assuming that the flow is adiabatic, frictionless, steady, and irrotational. A relationship is developed relating the volume percentage of the fluid vaporized during the cavitation process to the “thermal cavitation parameter.” Two assumptions are then introduced concerning the cavitation process in a pump pumping fluids of different cavitation characteristics. Using these assumptions, a relationship is derived indicating that the difference in net positive suction head (NPSH) of a given pump handling two fluids is a function of the difference of the reciprocals of the thermal cavitation parameter for the two fluids and of the volume percentage of the fluid vaporized. This relationship is compared with data describing the cavitation characteristics of six pumps handling four pure fluids. The change in NPSH for all of the pumps and fluids, using the cold-water NPSH as a reference, is found to correlate as a function of the reciprocal of the thermal cavitation parameter with an accuracy of ±1 ft in NPSH. Experimental and analytical methods for determining the cavitation characteristics of pumps handling petroleum-based hydrocarbon mixtures are then described. Cavitation data for two pumps handling gasoline, fuel oil, and crude oil are presented. The data correlation for pure fluids is extended to include cavitation data for petroleum-based hydrocarbon mixtures. It is found that mixtures exhibit an additional decrement in NPSH over that for pure fluids having the same value of the thermal cavitation parameter. This additional decrement is found to be temperature dependent.
Skip Nav Destination
Article navigation
July 1965
This article was originally published in
Journal of Engineering for Power
Research Papers
The Effects of Fluid Properties on Cavitation in Centrifugal Pumps
W. A. Spraker
W. A. Spraker
Mechanical Engineering Department, Battelle Memorial Institute, Columbus, Ohio
Search for other works by this author on:
W. A. Spraker
Mechanical Engineering Department, Battelle Memorial Institute, Columbus, Ohio
J. Eng. Power. Jul 1965, 87(3): 309-318 (10 pages)
Published Online: July 1, 1965
Article history
Received:
August 13, 1964
Online:
January 10, 2012
Citation
Spraker, W. A. (July 1, 1965). "The Effects of Fluid Properties on Cavitation in Centrifugal Pumps." ASME. J. Eng. Power. July 1965; 87(3): 309–318. https://doi.org/10.1115/1.3678264
Download citation file:
Get Email Alerts
Cited By
A Multi-Stage Nonlinear Method for Aeroengine Health Parameter Estimation Based on Adjacent Operating Points
J. Eng. Gas Turbines Power
A Combined Experimental and Turbulence-Resolved Modeling Approach for Aeroengine Turbine Rim Seals
J. Eng. Gas Turbines Power (August 2024)
Related Articles
Jet Pump Cavitation
J. Basic Eng (September,1970)
Experimental and Numerical Studies in a Centrifugal Pump With Two-Dimensional Curved Blades in Cavitating Condition
J. Fluids Eng (November,2003)
Development of High-Temperature Transport Technologies for Liquid Cadmium in Pyrometallurgical Reprocessing
J. Eng. Gas Turbines Power (July,2009)
Related Proceedings Papers
Related Chapters
General and Historical Information
Pipeline Integrity Assurance: A Practical Approach
Introduction
Design of Mechanical Bearings in Cardiac Assist Devices
Turbocompressors
Pumps and Compressors