This work used the established mathematic models of an intermediate-temperature solid oxide fuel cell (IT-SOFC) and gas turbine (GT) hybrid system fueled with wood chip gas to investigate the load performance and safe characteristic under off-design conditions. Three different operating modes (mode A: regulating the fuel proportionally, and the air is passively regulated. Mode B: regulating the fuel only. Mode C: simultaneously regulating the fuel and air) were chosen, and the component safety factors (such as fuel cell maximum temperature, compressor surge margin, carbon deposition in reformer) were considered. Results show that when the operation modes A and C are executed, the hybrid system output power can be safely changed from 41% to 104%, and 45% to 103%, respectively. When mode B is executed, the load adjustment range of hybrid system is from 20% to 134%, which is wider than that of two above operation modes. However, the safety characteristic in this case is very complicated. The system will suffer from two potential malfunctions caused by too lower temperature entering turbine and CH4/CO cracking in reforming reactor when it operates in low load conditions. When the system operates in the high load conditions exceeding 130% of relative power, the potential thermal cracking of fuel cell will be occurred.

References

1.
Grillo
,
O.
,
Magistri
,
L.
, and
Massardo
,
A. F.
,
2003
, “
Hybrid Systems for Distributed Power Generation Based on Pressurization and Heat Recovering of an Existing 100 kW Molten Carbonate Fuel Cell
,”
J. Power Sources
,
115
(
2
), pp.
252
267
.
2.
Santangelo
,
P. E.
, and
Tartarini
,
P.
,
2007
, “
Fuel Cell Systems and Traditional Technologies—Part I: Experimental CHP Approach
,”
Appl. Therm. Eng.
,
27
(
8–9
), pp.
1278
1284
.
3.
Beér
,
J. M.
,
2007
, “
High Efficiency Electric Power Generation: The Environmental Role
,”
Prog. Energy Combust. Sci.
,
33
(
2
), pp.
107
134
.
4.
Bang-Møller
,
C.
, and
Rokni
,
M.
,
2010
, “
Thermodynamic Performance Study of Biomass Gasification, Solid Oxide Fuel Cell and Micro Gas Turbine Hybrid Systems
,”
Energy Convers. Manage.
,
51
(
11
), pp.
2330
2339
.
5.
Kaneko
,
T.
,
Brouwer
,
J.
, and
Samuelsen
,
G. S.
,
2006
, “
Power and Temperature Control of Fluctuating Biomass Gas Fueled Solid Oxide Fuel Cell and Micro Gas Turbine Hybrid System
,”
J. Power Sources
,
160
(
1
), pp.
316
325
.
6.
Caliandro
,
P.
,
Tock
,
L.
,
Ensinas
,
A. V.
, and
Marechal
,
F.
,
2014
, “
Thermo-Economic Optimization of a Solid Oxide Fuel Cell-Gas Turbine System Fuelled With Gasified Lignocellulosic Biomass
,”
Energy Convers. Manage.
,
85
, pp.
764
773
.
7.
Arsalis
,
A.
,
2008
, “
Thermoeconomic Modeling and Parametric Study of Hybrid SOFC–Gas Turbine–Steam Turbine Power Plants Ranging From 1.5 to 10 MWe
,”
J. Power Sources
,
181
(
2
), pp.
313
326
.
8.
Meratizaman
,
M.
,
Monadizadeh
,
S.
, and
Amidpour
,
M.
,
2014
, “
Techno-Economic Assessment of High Efficient Energy Production (SOFC-GT) for Residential Application From Natural Gas
,”
J. Nat. Gas Sci. Eng.
,
21
, pp.
118
133
.
9.
Mazzucco
,
A.
, and
Rokni
,
M.
,
2014
, “
Thermo-Economic Analysis of a Solid Oxide Fuel Cell and Steam Injected Gas Turbine Plant Integrated With Woodchips Gasification
,”
Energy
,
76
, pp.
114
129
.
10.
Kimijima
,
S.
, and
Kasagi
,
N.
,
2002
, “
Performance Evaluation of Gas Turbine-Fuel Cell Hybrid Micro Generation System
,”
ASME
Paper No. GT-30111.
11.
Stiller
,
C.
,
Thorud
,
B.
, and
Bolland
,
O.
,
2006
, “
Control Strategy for a Solid Oxide Fuel Cell and Gas Turbine Hybrid System
,”
J. Power Sources
,
158
(
1
), pp.
303
315
.
12.
Stiller
,
C.
,
Thorud
,
B.
, and
Bolland
,
O.
,
2006
, “
Safe Dynamic Operation of a Simple SOFC/GT Hybrid System
,”
ASME J. Eng. Gas Turbines Power
,
128
(
3
), pp. 551–559.
13.
Calise
,
F.
,
Palombo
,
A.
, and
Vanoli
,
L.
,
2006
, “
Design and Partial Load Exergy Analysis of Hybrid SOFC-GT Power Plant
,”
J. Power Sources
,
158
(
1
), pp.
225
244
.
14.
Milewski
,
J.
,
Miller
,
A.
, and
Sałaci
,
N. J.
,
2007
, “
Off-Design Analysis of SOFC Hybrid System
,”
Int. J. Hydrogen Energy
,
32
(
6
), pp.
687
698
.
15.
Bakalis
,
D. P.
, and
Stamatis
,
A. G.
,
2012
, “
Full and Part Load Exergetic Analysis of a Hybrid Micro Gas Turbine Fuel Cell System Based on Existing Components
,”
Energy Convers. Manage.
,
64
, pp.
213
221
.
16.
Komatsu
,
Y.
,
Kimijima
,
S.
, and
Szmyd
,
J. S.
,
2010
, “
Performance Analysis for the Part-Load Operation of a Solid Oxide Fuel Cell–Micro Gas Turbine Hybrid System
,”
Energy
,
35
(
2
), pp.
982
988
.
17.
Lv
,
X.
,
Liu
,
X.
,
Gu
,
C.
, and
Weng
,
Y.
,
2016
, “
Determination of Safe Operation Zone for an Intermediate Temperature Solid Oxide Fuel Cell and Gas Turbine Hybrid System
,”
Energy
,
99
, pp.
91
102
.
18.
Lv
,
X.
,
Gu
,
C.
,
Liu
,
X.
, and
Weng
,
Y.
,
2016
, “
Effect of Gasified Biomass Fuel on Load Characteristics of an Intermediate-Temperature Solid Oxide Fuel Cell and Gas Turbine Hybrid System
,”
Int. J. Hydrogen Energy
,
41
(
22
), pp.
9563
9576
.
19.
Aguiar
,
P.
,
Adjiman
,
C. S.
, and
Brandon
,
N. P.
,
2004
, “
Anode Supported Intermediate Temperature Direct Internal Reforming Solid Oxide Fuel Cell—Part I: Model-Based Steady-State Performance
,”
J. Power Source
,
138
(
1–2
), pp.
120
136
.
20.
Liu
,
A.
, and
Weng
,
Y.
,
2009
, “
Numerical Simulation of Fuel Cells/Gas Turbine Hybrid Power System and Catalytic Combustion Experiment Study
,” Ph.D. thesis, Shanghai Jiao Tong University, Shanghai, China.
21.
Li
,
Y.
, and
Weng
,
Y.
,
2011
, “
Off-Design Analysis and Experiment Study of High Temperature Fuel Cell/Gas Turbine Hybrid System
,” Ph.D. thesis, Shanghai Jiao Tong University, Shanghai, China.
22.
Chan
,
S. H.
,
Ho
,
H. K.
, and
Tian
,
Y.
,
2003
, “
Modelling for Part-Load Operation of Solid Oxide Fuel Cell–Gas Turbine Hybrid Power Plant
,”
J. Power Sources
,
114
(
2
), pp.
213
227
.
23.
Roberts
,
R.
,
Brouwer
,
J.
, and
Jabbari
,
F.
,
Junker
,
T.
, and
Ghezel
,
H.
,
2006
, “
Control Design of an Atmospheric Solid Oxide Fuel Cell/Gas Turbine Hybrid System: Variable Versus Fixed Speed Gas Turbine Operation
,”
J. Power Sources
,
161
(
1
), pp.
484
491
.
24.
Bakalis
,
D. P.
, and
Stamatis
,
A. G.
,
2013
, “
Incorporating Available Micro Gas Turbines and Fuel Cell: Matching Considerations and Performance Evaluation
,”
Appl. Energy
,
103
, pp.
607
617
.
You do not currently have access to this content.