Flashback (FB) and self-ignition in the premixing zone of typical gas turbine swirl combustors in lean premixed operation are immanent risks and can lead to damage and failure of components. Thus, steady combustion in the premixing zone must be avoided under all circumstances. This study experimentally investigates the flame holding propensity of fuel injectors in the swirler of a gas turbine model combustor with premixing of H2–natural gas (NG)–air mixtures under atmospheric pressure and proposes a model to predict the limit for safe operation. The A2EV swirler concept exhibits a hollow, thick walled conical structure with four tangential slots. Four fuel injector geometries were tested. One of them injects the fuel orthogonal to the air flow in the slots (jet-in-crossflow injector, JICI). Three injector types introduce the fuel almost isokinetic to the air flow at the trailing edge of the swirler slots (trailing edge injector, TEI). A cylindrical duct and a window in the swirler made of quartz glass allow the application of optical diagnostics (OH* chemiluminescence and planar laser induced fluorescence of the OH radical (OH-PLIF)) inside the swirler. The fuel–air mixture was ignited with a focused single laser pulse during steady operation. The position of ignition was located inside the swirler in proximity to a fuel injection hole. If the flame was washed out of the premixing zone not later than 4 s after the ignition, the operation point was defined as safe. Operation points were investigated at three air mass flows, three air ratios, two air preheat temperatures (573 K and 673 K), and 40 to 100 percent per volume hydrogen in the fuel composed of hydrogen and natural gas. The determined safety limit for atmospheric pressure yields a similarity rule based on a critical Damköhler number. Application of the proposed rule at conditions typical for gas turbines leads to these safety limits for the A2EV burner: With the TEIs, the swirler can safely operate with up to 80 percent per volume hydrogen content in the fuel at an air ratio of two. With the JIC injector, safe operation at stoichiometric conditions and 95 percent per volume hydrogen is possible.
Flame Holding in the Premixing Zone of a Gas Turbine Model Combustor After Forced Ignition of H2–Natural Gas–Air Mixtures
Technische Universität München,
Garching 85748, Germany
Contributed by the Combustion and Fuels Committee of ASME for publication in the JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Manuscript received July 1, 2016; final manuscript received August 2, 2016; published online October 26, 2016. Editor: David Wisler.
- Views Icon Views
- Share Icon Share
- Search Site
Utschick, M., and Sattelmayer, T. (October 26, 2016). "Flame Holding in the Premixing Zone of a Gas Turbine Model Combustor After Forced Ignition of H2–Natural Gas–Air Mixtures." ASME. J. Eng. Gas Turbines Power. April 2017; 139(4): 041504. https://doi.org/10.1115/1.4034647
Download citation file: