In this paper, we present recent experimental results on forced convective heat transfer in novel finned metal foam heat sinks. Experiments were conducted on aluminum foams of 90 percent porosity and pore size corresponding to 5 PPI (200 PPM) and 20 PPI (800 PPM) with one, two, four and six fins, where PPI (PPM) stands for pores per inch (pores per meter) and is a measure of the pore density of the porous medium. All of these heat sinks were fabricated in-house. The forced convection results show that heat transfer is significantly enhanced when fins are incorporated in metal foam. The heat transfer coefficient increases with increase in the number of fins until adding more fins retards heat transfer due to interference of thermal boundary layers. For the 20 PPI samples, this maximum was reached for four fins. For the 5 PPI heat sinks, the trends were found to be similar to those for the 20 PPI heat sinks. However, due to larger pore sizes, the pressure drop encountered is much lower at a particular air velocity. As a result, for a given pressure drop, the heat transfer coefficient is higher compared to the 20 PPI heat sink. For example, at a $Δp$ of 105 Pa, the heat transfer coefficients were found to be $1169W/m2-K$ and $995W/m2-K$ for the 5 PPI and 20 PPI 4-finned heat sinks, respectively. The finned metal foam heat sinks outperform the longitudinal finned and normal metal foam heat sinks by a factor between 1.5 and 2, respectively. Finally, an analytical expression is formulated based on flow through an open channel and incorporating the effects of thermal dispersion and interfacial heat transfer between the solid and fluid phases of the porous medium. The agreement of the proposed relation with the experimental results is promising.

1.
Semiconductor Industry Association, 1998, The national technology roadmap for semiconductors, SIA, California.
2.
Kraus, A. D., and Bar-Cohen, A., 1983, Thermal analysis and control of electronic equipment, Hemisphere, New York.
3.
Incropera
,
F. P.
,
1988
, “
Convection heat transfer in electronic equipment cooling
,”
ASME J. Heat Transfer
,
110
, pp.
1097
1111
.
4.
Peterson
,
G. P.
, and
Ortega
,
A.
,
1990
, “
Thermal control of electronic equipment and devices
,”
,
20
, pp.
181
314
.
5.
Tuckerman
,
D. B.
, and
Pease
,
R. F. W.
,
1981
, “
High Performance heat sinking for VLSI
,”
IEEE Electron Device Lett.
,
EDL-2
, No.
5
, pp.
126
129
.
6.
Goldberg
,
N.
,
1984
, “
Narrow channel forced air heat sink
,”
IEEE Trans. Compon., Hybrids, Manuf. Technol.
,
7
, No.
1
, pp.
154
159
.
7.
Bejan
,
A.
, and
Sciubba
,
E.
,
1992
, “
The optimal spacing of parallel plates cooled by forced convection
,”
Int. J. Heat Mass Transf.
,
35
, pp.
3259
3264
.
8.
Knight
,
R. W.
,
Goodling
,
J. S.
, and
Hall
,
D. J.
,
1991
, “
Optimal thermal design of forced convection heat sinks–analytical
,”
ASME J. Heat Transfer
,
113
, pp.
313
321
.
9.
Lau
,
K. S.
, and
Mahajan
,
R. L.
,
1989
, “
Effects of tip clearance and fin density on the performance of heat sinks for VLSI packages
,”
IEEE Trans. Compon., Hybrids, Manuf. Technol.
,
12
, No. 4,
757
765
.
10.
Sparrow
,
E. M.
,
Baliga
,
B. R.
, and
Patankar
,
S. V.
,
1978
, “
Forced convective heat transfer from a shrouded fin array with and without tip clearance
,”
ASME J. Heat Transfer
,
100
, pp.
572
579
.
11.
,
D. S.
, and
Sparrow
,
E. M.
,
1986
, “
Numerical and experimental study on turbulent heat transfer and fluid flow in longitudinal fin arrays
,”
ASME J. Heat Transfer
,
108
, pp.
16
23
.
12.
Jelenik, M., “Optimum array of cooling fins,” MS Thesis, Ben-Gurion University of Negev, Beer Sheva, Israel.
13.
Sathe, S. B., Sammakia, B. G., Wong, A. C., and Mahaney, H. V., 1995 “A numerical study of a high-performance air-cooled heat sink,” National Heat Transfer Conference–Volume 1, HTD ASME, Vol. 303, pp. 43–53.
14.
Hilbert
,
C.
,
Sommerfeldt
,
S.
,
Gupta
,
O.
, and
Herell
,
D. J.
,
1990
, “
High performance air cooled heat sinks for integrated circuits
,”
IEEE Trans. Compon., Hybrids, Manuf. Technol.
,
13
, No.
4
, pp.
1022
31
.
15.
Hwang
,
L. T.
,
Turlik
,
I.
, and
Reisman
,
A.
,
1987
, “
A thermal module design for advanced packaging
,”
J. Electron. Mater.
,
16
, No.
5
, pp.
347
355
.
16.
Calmidi, V. V., 1998, “Transport Phenomena in High Porosity Metal Foams,” Ph.D. thesis, University of Colorado.
17.
Calmidi, V. V., Calmidi M., and Mahajan, R. L., 2000, “Finned Metal Foam Heat Sink,” U.S. patent filed, University of Colorado.
18.
Calmidi
,
V. V.
, and
Mahajan
,
R. L.
,
2000
, “
Forced Convection in High Porosity Metal Foams
,”
ASME J. Heat Transfer
,
122
, pp.
557
565
.
19.
Hunt
,
M. L.
, and
Tien
,
C. L.
,
1988
, “
Effects of Thermal Dispersion on Forced Convection in Fibrous Media
,”
Int. J. Heat Mass Transf.
,
31
, pp.
301
309
.
20.
Lu
,
T. J.
,
Stone
,
H. A.
, and
Ashby
,
M. F.
,
1998
, “
Heat transfer in open-cell metal foams
,”
Acta Mater.
,
46
, pp.
3619
3635
.
21.
Lee, Y. C., Zhang, W., Xie, H., and Mahajan, R. L., 1993 “Cooling of a FCHIP package with 100 W, 1cm2 chip,” Proceedings of the 1993 ASME Int. Elec. Packaging Conference, Vol. 1, pp. 419–423.
22.
Bhattacharya
,
A.
,
Calmidi
,
V. V.
, and
Mahajan
,
R. L.
,
2002
, “
Thermophysical Properties of High Porosity Metal Foams
,”
Int. J. Heat Mass Transf.
,
45
, pp.
1017
1031
.
23.
Bejan, A., 1993, Heat Transfer, Wiley, New York.
24.
Nield, D. A., and Bejan, A., 1999, Convection in porous media, 2nd ed., Springer-Verlag, New York.
25.
Taylor, T. R., 1980, An Introduction to Error Analysis—The Study of Uncertainties in Physical Measurements, University Science Books, Mill Valley, California.
26.
Calmidi
,
V. V.
, and
Mahajan
,
R. L.
,
1999
, “
The effective thermal conductivity of high porosity metal foams
,”
ASME J. Heat Transfer
,
121
, pp.
466
471
.
27.
Hsu
,
C. T.
, and
Cheng
,
P.
,
1990
, “
Thermal Dispersion in a porous medium
,”
Int. J. Heat Mass Transf.
,
33
, pp.
1587
1597
.
28.
Cheng, P., Chowdhury, A., and Hsu, C. T., 1990, “Free Convection in packed tubes and channels with variable porosity and thermal dispersion effects,” Convective Heat and Mass Transfer in Porous Media, NATO ASI Series, Series E, Applied Sciences—Vol. 196, Kakac, S. et al., eds. pp. 625–653.
29.
Verschoor
,
H.
, and
Schuit
,
G. C. A.
,
1952
, “
Heat Transfer to fluids flowing through a bed of granular solids
,”
Appl. Sci.
,
42
, pp.
97
119
.
30.
Nield
,
D. A.
,
1998
, “
Effects of Local Thermal Nonequilibrium in Steady Convective Processes in a Saturated Porous Medium: Forced Convection in a Channel
,”
Journal of Porous Media
,
1
(
2
), pp.
181
186
.