Skip Nav Destination
Introduction to Plastics Engineering
ISBN:
9781119536574
No. of Pages:
1060
Publisher:
ASME Press
Publication date:
2020
eBook Chapter
16. Classification of Part Shaping Methods
Page Count:
23
-
Published:2020
Plastics are relatively expensive materials. Their usefulness stems from styling freedom in design – allowing for parts with complex surfaces – and from the complexity of parts that can be made – thereby cutting inventory and assembly costs. Together with part complexity, low-cost partmanufacturing is what makes the use of otherwise expensive plastic materials competitive.
This content is only available via PDF.
You do not currently have access to this chapter.
Email alerts
Related Chapters
Nonmetallic Pressure Piping System Components Part A: Experience With Nonmetallic Materials in Structural/Pressure Boundary Applications
Online Companion Guide to the ASME Boiler & Pressure Vessel Codes
Nonmetallic Pressure Piping System Components 1 Part A: Experience With Nonmetallic Materials in Structural/Pressure Boundary Applications
Companion Guide to the ASME Boiler and Pressure Vessel Codes, Volume 1, Fifth Edition
Utilizing Waste Materials as a Source of Alternative Energy: Benefits and Challenges
Energy and Power Generation Handbook: Established and Emerging Technologies
Section III: Subsections NC and ND—Class 2 and 3 Components
Companion Guide to the ASME Boiler & Pressure Vessel Codes, Volume 1 Sixth Edition
Related Articles
The Development of a Heterogeneous Composite Bipolar Plate of a Proton Exchange Membrane Fuel Cell
J. Fuel Cell Sci. Technol (February,2005)