This paper presents an optimized input-shaped model reference control (OIS-MRC) for limiting oscillation of multimode flexible systems. The controller is analyzed by using it to control an uncertain, time-varying double pendulum using a linear single-pendulum reference model. Single- and double-pendulum dynamics are presented, and the significant natural frequency ranges of the double pendulum are calculated. A Lyapunov control law using only the first mode states of the plant is obtained. An optimization technique is used to obtain the OIS-MRC controller parameters that realizes the shortest time duration, while meeting a set of design constraints. The oscillation suppression, control effort reduction, and disturbance rejection performances of the proposed OIS-MRC controller are tested via numerical simulations and experiments. The OIS-MRC achieves a robust oscillation suppression performance, while reducing the rise time.
Issue Section:
Research Papers
References
1.
Starr
, G. P.
, 1985
, “Swing-Free Transport of Suspended Objects With a Path-Controlled Robot Manipulator
,” ASME J. Dyn. Syst. Meas. Control
, 107
(1
), pp. 97
–100
.2.
Lee
, H.
, Liang
, Y.
, and Segura
, D.
, 2006
, “A Sliding-Mode Antiswing Trajectory Control for Overhead Cranes With High Speed Load Hoisting
,” ASME J. Dyn. Syst. Meas. Control
, 128
(4
), pp. 842
–845
.3.
Rauch
, A.
, Singhose
, W.
, Fujioka
, D.
, and Jones
, T.
, 2013
, “Tip-Over Stability Analysis of Mobile Boom Cranes With Swinging Payloads
,” ASME J. Dyn. Syst. Meas. Control
, 135
(3
), p. 031008
.4.
Ekrekli
, A.
, and Brookfield
, D. J.
, 1997
, “The Practical Implementation of Model Reference Robot Control
,” Mechatronics
, 7
(6
), pp. 549
–564
.5.
Hovakimyan
, N.
, Rysdyk
, R.
, and Calise
, A. J.
, 1999
, “Dynamic Neural Networks for Output Feedback Control
,” 38th IEEE Conference on Decision and Control
(CDC
), Phoenix, AZ, Dec. 7–10, pp. 1685
–1690
.6.
Singer
, N. C.
, and Seering
, W. P.
, 1990
, “Preshaping Command Inputs to Reduce System Vibration
,” ASME J. Dyn. Syst. Meas. Control
, 112
(1
), pp. 76
–82
.7.
Smith
, O. J. M.
, 1957
, “Posicast Control of Damped Oscillatory Systems
,” Inst. Radio Eng.
, 45
(9
), pp. 1249
–1255
.8.
Sorensen
, K. L.
, Singhose
, W.
, and Dickerson
, S.
, 2007
, “A Controller Enabling Precise Positioning and Sway Reduction in Bridge and Gantry Cranes
,” Control Eng. Pract.
, 15
(7
), pp. 825
–837
.9.
Singhose
, W.
, Kim
, D.
, and Kenison
, M.
, 2008
, “Input Shaping Control of Double-Pendulum Bridge Crane Oscillations
,” ASME J. Dyn. Syst. Meas. Control
, 130
(3
), p. 034504.10.
Masoud
, Z. N.
, and Alhazza
, K. A.
, 2014
, “Frequency-Modulation Input Shaping Control of Double-Pendulum Overhead Cranes
,” ASME J. Dyn. Syst. Meas. Control
, 136
(2
), p. 021005.11.
Danielson
, J.
, Lawrence
, J.
, and Singhose
, W.
, 2008
, “Command Shaping for Flexible Systems Subject to Constant Acceleration Limits
,” ASME J. Dyn. Syst. Meas. Control
, 130
(5
), p. 051011.12.
Wie
, B.
, Sinha
, R.
, and Liu
, Q.
, 1993
, “Robust Time-Optimal Control of Uncertain Structural Dynamic Systems
,” AIAA J. Guid. Control Dyn.
, 15
(5
), pp. 980
–983
.13.
Singh
, T.
, and Vadali
, S.
, 1994
, “Robust Time-Optimal Control: A Frequency Domain Approach
,” AIAA J. Guid. Control Dyn.
, 17
(2
), pp. 346
–353
.14.
Gorinevsky
, D.
, and Vukovich
, G.
, 1998
, “Nonlinear Input Shaping Control of Flexible Spacecraft Reorientation Maneuver
,” AIAA J. Guid. Control Dyn.
, 21
(2
), pp. 264
–270
.15.
Jones
, S.
, and Ulsoy
, A. G.
, 1999
, “An Approach to Control Input Shaping With Application to Coordinate Measuring Machines
,” ASME J. Dyn. Syst. Meas. Control
, 121
(2
), pp. 242
–247
.16.
Singhose
, W.
, Seering
, W.
, and Singer
, N.
, 1997
, “Time-Optimal Negative Input Shapers
,” ASME J. Dyn. Syst. Meas. Control
, 119
(2
), pp. 198
–205
.17.
Khalid
, A.
, Huey
, J.
, Singhose
, W.
, Lawrence
, J.
, and Frakes
, D.
, 2006
, “Human Operator Performance Testing Using an Input-Shaped Bridge Crane
,” ASME J. Dyn. Syst. Meas. Control
, 128
(4
), pp. 835
–841
.18.
Vaughan
, J.
, Jurek
, P.
, and Singhose
, W.
, 2011
, “Reducing Overshoot in Human-Operated Flexible Systems
,” ASME J. Dyn. Syst. Meas. Control
, 133
(1
), p. 011010
.19.
Potter
, J.
, and Singhose
, W.
, 2014
, “Effects of Input Shaping on Manual Control of Flexible and Time-Delayed Systems
,” J. Hum. Factors Ergonom. Soc.
, 56
(7
), pp. 1284
–1295
.20.
Kenison
, M.
, and Singhose
, W.
, 2002
, “Concurrent Design of Input Shaping and Proportional Plus Derivative Feedback Control
,” ASME J. Dyn. Syst. Meas. Control
, 124
(3
), pp. 398
–405
.21.
Yu
, L.
, and Chang
, T. N.
, 2008
, “Model Reference Zero Vibration Balance Control of Dual Solenoid Position Actuator
,” International Symposium on Flexible Automation
, Atlanta, GA, June 23–26.22.
Yu
, L.
, and Chang
, T. N.
, 2010
, “Zero Vibration On-Off Position Control of Dual Solenoid Actuator
,” IEEE Trans. Ind. Electron.
, 57
(7
), pp. 2519
–2526
.23.
Yuan
, D.
, and Chang
, T.
, 2006
, “Trajectory Control of Robot With Model Reference Zero Vibration Shaper
,” IEEE
Third International Conference on Mechatronics
, Budapest, Hungary, July 3–5, pp. 636
–641
.24.
Yuan
, D.
, and Chang
, T. N.
, 2008
, “Model Reference Input Shaper Design With Applications to a High-Speed Robotic Workcell With Variable Loads
,” IEEE Trans. Ind. Electron.
, 55
(2
), pp. 842
–851
.25.
Mingxiao
, D.
, Bo Pang
, F. L.
, and Liu
, H.
, 2010
, “Analysis on Payload Oscillation, Actuator Effort and Energy Usage of PD Combined With Input-Shaping for Bridge Cranes
,” J. Basic Sci. Eng.
, 18
(5
), pp. 832
–837
.26.
Dong
, M.
, Pang
, B.
, Li
, F.
, and Liu
, H.
, 2011
, “Effect of Input Shaping on Actuator Effort of Inertial Plants
,” Key Eng. Mater
., 464
, pp. 138
–141
.27.
Fujioka
, D.
, and Singhose
, W.
, 2014
, “Control Effort Reduction Analysis of Zero-Vibration Model Reference Control for Controlling a Time-Varying Plant
,” American Control Conference
(ACC
), Portland, OR, June 4–6, pp. 3110
–3115
.28.
Fujioka
, D.
, Shah
, M.
, and Singhose
, W.
, 2015
, “Robustness Analysis of Input-Shaped Model Reference Control on a Double-Pendulum Crane
,” American Control Conference
(ACC
), Chicago, IL, July 1–3, pp. 2561
–2566
.29.
Fujioka
, D.
, and Singhose
, W.
, 2015
, “Input-Shaped Model Reference Control of a Nonlinear Time-Varying Double-Pendulum Crane
,” Tenth Asian Control Conference
(ASCC
), Kota Kinabalu, Malaysia, May 31–June 3, pp. 1
–6
.30.
Fujioka
, D.
, and Singhose
, W.
, 2015
, “Performance Comparison of Input-Shaped Model Reference Control on an Uncertain Flexible System
,” International Federation of Automatic Control—Workshop on Time Delay Systems
, Ann Arbor, MI, June 28–30, pp. 129
–134
.31.
Blevins
, R.
, 1979
, Formulas for Natural Frequency and Mode Shape
, Van Nostrand Reinhold
, New York
.32.
Fujioka
, D. D.
, 2017
, “Input-Shaped Model Reference Control for Flexible Systems,” Ph.D. thesis, Georgia Institute of Technology, Atlanta, GA.33.
Kuo
, B. C.
, 1995
, Automatic Control Systems
, 7th ed., Prentice Hall
, Upper Saddle River, NJ, Chap. 7.5.34.
Kozak
, K.
, Singhose
, W.
, and Ebert-Uphoff
, I.
, 2006
, “Performance Measures for Input Shaping and Command Generation
,” ASME J. Dyn. Syst. Meas. Control
, 128
(3
), pp. 731
–736
.Copyright © 2018 by ASME
You do not currently have access to this content.
