This paper presents two observers for estimating the aging condition of selective catalytic reduction (SCR) systems in vehicle applications. SCR systems have been widely recognized as one of the leading engine exhaust gas aftertreatment systems for reducing diesel powertrain tailpipe NOx emissions in ground vehicle applications. While fresh SCRs are quite effective in reducing tailpipe NOx emissions, their NOx reduction capabilities and performances may substantially degrade with in-service aging. To maintain the emission control performance of a SCR system for a diesel engine during the entire vehicle service life, it is thus critical to have an accurate estimation of the SCR system aging condition. In this paper, two Lyapunov-based observers utilizing the measurements of NOx and ammonia concentrations are analytically developed and verified in simulations for estimating the SCR aging condition. The measurement uncertainty is explicitly considered in the observer design process. A sufficient condition for the boundedness of the estimation error is derived. Simulation results under the US06 test cycle demonstrate the effectiveness of the proposed observers.
Skip Nav Destination
Article navigation
February 2017
Research-Article
Observer-Based Estimation of Aging Condition for Selective Catalytic Reduction Systems in Vehicle Applications
Yao Ma,
Yao Ma
Department of Mechanical
and Aerospace Engineering,
The Ohio State University,
Columbus, OH 43210
e-mail: ma.506@osu.edu
and Aerospace Engineering,
The Ohio State University,
Columbus, OH 43210
e-mail: ma.506@osu.edu
Search for other works by this author on:
Junmin Wang
Junmin Wang
Fellow ASME
Department of Mechanical
and Aerospace Engineering,
The Ohio State University,
Columbus, OH 43210
e-mail: wang.1381@osu.edu
Department of Mechanical
and Aerospace Engineering,
The Ohio State University,
Columbus, OH 43210
e-mail: wang.1381@osu.edu
Search for other works by this author on:
Yao Ma
Department of Mechanical
and Aerospace Engineering,
The Ohio State University,
Columbus, OH 43210
e-mail: ma.506@osu.edu
and Aerospace Engineering,
The Ohio State University,
Columbus, OH 43210
e-mail: ma.506@osu.edu
Junmin Wang
Fellow ASME
Department of Mechanical
and Aerospace Engineering,
The Ohio State University,
Columbus, OH 43210
e-mail: wang.1381@osu.edu
Department of Mechanical
and Aerospace Engineering,
The Ohio State University,
Columbus, OH 43210
e-mail: wang.1381@osu.edu
Contributed by the Dynamic Systems Division of ASME for publication in the JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL. Manuscript received January 21, 2016; final manuscript received August 5, 2016; published online October 20, 2016. Assoc. Editor: Ardalan Vahidi.
J. Dyn. Sys., Meas., Control. Feb 2017, 139(2): 021002 (9 pages)
Published Online: October 20, 2016
Article history
Received:
January 21, 2016
Revised:
August 5, 2016
Citation
Ma, Y., and Wang, J. (October 20, 2016). "Observer-Based Estimation of Aging Condition for Selective Catalytic Reduction Systems in Vehicle Applications." ASME. J. Dyn. Sys., Meas., Control. February 2017; 139(2): 021002. https://doi.org/10.1115/1.4034508
Download citation file:
Get Email Alerts
Cited By
Offset-Free Koopman Model Predictive Control of Thermal Comfort Regulation for A VRF-DOAS Combined System
J. Dyn. Sys., Meas., Control
Rejection of Sinusoidal Disturbances With Unknown Slowly Time-Varying Frequencies for Linear Time-Varying Systems
J. Dyn. Sys., Meas., Control (July 2024)
Using Control Barrier Functions to Incorporate Observability: Application to Range-Based Target Tracking
J. Dyn. Sys., Meas., Control (July 2024)
Gas Path Fault Diagnosis of Turboshaft Engine Based on Novel Transfer Learning Methods
J. Dyn. Sys., Meas., Control (May 2024)
Related Articles
Robust Nonlinear Disturbance Observer Design for Estimation of Ammonia Storage Ratio in Selective Catalytic Reduction Systems
J. Dyn. Sys., Meas., Control (December,2015)
NO x Sensor Ammonia-Cross-Sensitivity Factor Estimation in Diesel Engine Selective Catalytic Reduction Systems
J. Dyn. Sys., Meas., Control (June,2015)
Simultaneous Estimation of Vehicle’s Center of Gravity and Inertial Parameters Based on Ackermann’s Steering Geometry
J. Dyn. Sys., Meas., Control (March,2017)
Robust Filtering for Ammonia Coverage Estimation in Diesel Engine Selective Catalytic Reduction Systems
J. Dyn. Sys., Meas., Control (November,2013)
Related Proceedings Papers
Related Chapters
Practical Applications
Robust Control: Youla Parameterization Approach
Review of Basic Principles
Fundamentals of heat Engines: Reciprocating and Gas Turbine Internal Combustion Engines
Engineering Design about Electro-Hydraulic Intelligent Control System of Multi Axle Vehicle Suspension
International Conference on Instrumentation, Measurement, Circuits and Systems (ICIMCS 2011)