This paper presents novel approaches to nonlinear engine fuel controller and cylinder pressure observer designs based on mean torque production and cylinder-by-cylinder models. Sliding mode controllers and sliding mode observers have shown good robustness and high tracking performance. Accordingly, they are selected in this study to fulfill demanding engine electronic control and onboard diagnostics requirements.

1.
Astrom, K. J., and Wittenmark B., Computer-Controlled System, Theory and Design, Prentice-Hall, 1990.
2.
Borman
G.
, and
Nishiwaki
K.
, “
A Review of Internal Combustion Engine Heat Transfer
,”
Prog. Energy Combust. Sci.
, Vol.
13
,
1987
, pp.
1
46
.
3.
Canudas de Wit
C.
, and
Slotine
J.-J. E.
, “
Sliding Observers for Robot Manipulators
,”
Automatica
, Vol.
27
, No.
5
,
1991
, pp.
859
864
.
4.
Cho, D., and Hedrick, J. K., “A Nonlinear Controller Design Method for Fuel-Injected Automotive Engines,” ASME Journal of Engineering for Gas Turbines and Power, Vol. 110, No. 2, July 1988.
5.
Cho, D., and Hedrick, J. K., “Sliding Mode Fuel-Injection Controller: Its Advantages,” ASME JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL, Vol. 113, Sept. 1991.
6.
Choi, S. B., and Hedrick, J. K., “Experimental Implementation of Sliding Controls on Automotive Engines,” Proc. American Control Conference, Chicago, IL, 1992.
7.
Citron, S. J., O’Higgins, J. E., and Chen, L. Y., “Cylinder by Cylinder Engine Pressure and Pressure Torque Waveform Determination Utilizing Speed Fluctuations,” SAE Paper No. 890486, 1989.
8.
Connolly, F. T., and Yagle, A. E., “Modeling and Identification of the Combustion Pressure Process in Internal Combustion Engines Using Engine Speed Fluctuations,” ASME Publication DSC-Vol. 44, Transportation Systems, 1992, pp. 191–206.
9.
Frank
P. M.
, “
Fault Diagnosis in Dynamic Systems Using Analytical and Knowledge-Based Redundancy—A Survey and Some New Results
,”
Automatica
, Vol.
26
, No.
3
,
1990
, pp.
459
474
.
10.
Green, J. H., and Hedrick, J. K., “Nonlinear Speed Control for Automotive Engines,” Proc. American Control Conference, San Diego, CA, 1990.
11.
Heywood, J. B., Internal Combustion Engine Fundamentals, McGraw-Hill, 1988.
12.
Iida, K., Akishino, K., and Kido, K., “IMEP Estimation from Instantaneous Crankshaft Torque Variation,” SAE Paper No. 900617, 1990.
13.
Kao, M., and Moskwa, J. J., “Engine Load and Equivalence Ratio Estimation for Control and Diagnostics Via Nonlinear Sliding Observer,” Presented at American Control Conference, Baltimore, Md., June 1994.
14.
Kao, M., and Moskwa, J. J., “Nonlinear Cylinder and Intake Manifold Pressure Observers for Engine Control and Diagnostics,” Presented at SAE International Congress & Exposition, Detroit, Mi., SAE Paper 940375, Feb. 1994.
15.
Kao, M., and Moskwa, J. J., “Turbocharged Diesel Engine Modeling for Nonlinear Engine Control and State Estimation,” ASME JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL, Vol. 117, Mar. 1995.
16.
Lei, Ning, “A Cycle Simulation Program for the Dynamic Operation of a Single Cylinder Direct Injection Diesel,” Department of Mechanical Engineering, University of Wisconsin-Madison, M.S. thesis, 1988.
17.
Lewandowski, E. J., and Moskwa, J. J., “On Guaranteeing Global Stability with Sliding Mode Control, Theory and Experiment,” Proc. American Control Conference, Boston, MA, 1991.
18.
Lewandowski, E. J., “Control of a Hydrostatic Powertrain for Automotive Applications,” Department of Mechanical Engineering, University of Wisconsin-Madison, Ph.D. thesis, 1990.
19.
Masmoudi, R. A., and Hedrick, J. K., “Estimation of Vehicle Shaft Torque Using Nonlinear Observers,” ASME JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL, Vol. 114, Sept. 1992.
20.
Misawa, E. A., and Hedrick, J. K., “Nonlinear Observers—A State-of-the Art Survey,” ASME JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL, Vol. 111, Sept. 1989.
21.
Moskwa, J. J., and Hedrick, J. K., “Modeling and Validation of Automotive Engines for Control Algorithm Development,” ASME JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL, Vol. 113, June 1992.
22.
Moskwa, J. J., and Hedrick, J. K., “Nonlinear Algorithm for Automotive Engine Control,” IEEE Control Systems Magazine, Apr. 1990.
23.
Moskwa, J. J., and Hedrick, J. K., “Sliding Mode Control of Automotive Engines,” Proc. American Control Conference, Pittsburgh, PA, 1989.
24.
Moskwa, J. J., “Automotive Engine Modeling for Real Time Control,” Department of Mechanical Engineering, M.I.T., Ph.D. thesis, 1988.
25.
Powell, B. K., Lawson, G. P., and Hogh, G., “Advanced Real Time Powertrain Systems Analysis,” ASME Paper 87-ICE-46, 1987.
26.
Ribbens, W. B. and Rizzoni, G., “Applications of Precise Crankshaft Position Measurements for Engine Testing, Control and Diagnosis,” SAE Paper No. 890885, 1989.
27.
Slotine, J-J. E., and Li, W., Applied Nonlinear Control, Prentice Hall, 1991.
28.
Slotine, J.-J. E., Hedrick, J. K., and Misawa, E. A., “On Sliding Observers for Nonlinear Systems,” ASME JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL, Vol. 109, Sept. 1987.
29.
Srinivasan, K., Rizzoni, G., Trigui, M., and Luh, G., “On-line Estimation of Net Engine Torque from Crankshaft Angular Velocity Measurement Using Repetitive Estimators,” Proc. American Control Conference, Chicago, IL, 1992.
30.
Wagner, J. and Shoureshi, R., “Observer Designs for Diagnostics of Nonlinear Process and Systems,” ASME Paper 88-WA/DSC-5, Presented at ASME Winter Annual Meeting, Chicago, IL, 1988.
31.
Walcott, B. L. and Zak, S. H., “Observation of Dynamical Systems in the Presence of Bounded Nonlinearities/Uncertainties,” Proc. of 25th Conference on Decision and Control, pp. 961–966, Athens, Greece, Dec. 1986.
32.
Walcott
B. L.
,
Corless
M. J.
, and
Zak
S. H.
, “
Comparative Study of Non-linear State-observation Techniques
,”
Int. J. Control
, Vol.
45
, No.
6
,
1987
, pp.
2109
2132
.
33.
Watson, N., “Dynamic Turbocharged Diesel Engine Simulator for Electronic Control System Development,” ASME JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL, Vol. 106, Mar. 1984.
This content is only available via PDF.
You do not currently have access to this content.