Fabrication and Characterization of Nanostructured Surface Layer of 38CrSi Steel

A nanocrystalline surface layer was fabricated on a 38CrSi Steel with tempered sorbite structure by using Supersonic Fine Particles Bombarding (SFPB). The microstructural evolution of SFPB-treated specimens under different processing conditions was characterized by using X-ray diffraction, scanning electron microscopy and transmission electron microscopy. Experimental evidence showed severe plastic deformation and obvious grains refinement were observed and a nanocrystalline surface layer (grain size < 100nm) was found after SFPB treatment. The thickness of nanostructured surface layer varies from a few to about 25μm as treated time increasing from 80s to 240s, but the grain size varies slightly. For the sample treated for 240s, the average grain size of equiaxed nanocrystallites with random crystallographic orientations on the top surface layer is about 16nm. The indexing of diffraction rings indicates nanostructured surface layer consists of ferrite and cementite phases without any evidence of a new phase. The structure size increases gradually from nano-scale to original-scale with an increase of the distance from the top surface layer. In the region about 20–30μm deep from the top surface, the microstructures are mainly composed of 60–100nm roughly equiaxed grains and subgrains. Some subbounsaries are composed of dense dislocation walls (DDWs). In this regime some cell structures are also seen, which are separated by dislocation lines (DTs) and some DDWs. Experimental analysis indicate coarse-grains are gradually refined into nano-sized grains by dislocations activity with gradual increase of strain and strain rate from matrix to treated surface. Both ferrite and cementite phases occur grain refinement. Grain refinement of 38CrSi sample is mainly attributed to the movement of dislocation.