The increasing interest in concentrated solar power as a new form of renewable energy necessitates an improvement in overall system efficiency. Current heat transfer fluids employed to capture the concentrated heat demonstrate limited working temperature ranges. This study sought to investigate the use of dense granular flows as a possible new heat transfer fluid, as ceramic particles present virtually no restriction on working temperature. A bench-scale system simulating a single tube of a concentrated solar power central receiver was constructed and used to evaluate the heat transfer properties of the flow at low temperatures. Ceramic particles, 270μm in diameter, were gravity-fed through a vertical tube, resulting in granular flows with particle packing fractions of approximately 60%. Radial temperature profiles were measured and used to calculate the mean temperature of the fluid at different axial tube locations. The heat transfer coefficient was then calculated based on the input heat flux and measured wall and mean temperatures. The effect of the mass flow rate on the heat transfer coefficient was examined by using different orifices at the tube exit. As expected, the heat transfer coefficient increased with increasing flow rate. Heat transfer coefficients ranging from 330 to 380 W/m2-K were obtained for bulk temperatures ranging from 40 to 70°C. Previous works demonstrated comparable heat transfer coefficients at higher bulk temperatures. Thus, our preliminary heat transfer coefficient results demonstrate the potential of dense flows of ceramic particles for obtaining beneficial heat transfer properties at extremely high operating temperatures.
Skip Nav Destination
ASME 2015 International Mechanical Engineering Congress and Exposition
November 13–19, 2015
Houston, Texas, USA
Conference Sponsors:
- ASME
ISBN:
978-0-7918-5750-2
PROCEEDINGS PAPER
Dense Granular Flows as a New Heat Transfer Fluid for Concentrated Solar Power
Megan F. Watkins,
Megan F. Watkins
North Carolina State University, Raleigh, NC
Search for other works by this author on:
Richard D. Gould
Richard D. Gould
North Carolina State University, Raleigh, NC
Search for other works by this author on:
Megan F. Watkins
North Carolina State University, Raleigh, NC
Richard D. Gould
North Carolina State University, Raleigh, NC
Paper No:
IMECE2015-51069, V08BT10A006; 7 pages
Published Online:
March 7, 2016
Citation
Watkins, MF, & Gould, RD. "Dense Granular Flows as a New Heat Transfer Fluid for Concentrated Solar Power." Proceedings of the ASME 2015 International Mechanical Engineering Congress and Exposition. Volume 8B: Heat Transfer and Thermal Engineering. Houston, Texas, USA. November 13–19, 2015. V08BT10A006. ASME. https://doi.org/10.1115/IMECE2015-51069
Download citation file:
38
Views
Related Proceedings Papers
Related Articles
An Experimental Evaluation of the Effective Thermal Conductivities of Packed Beds at High Temperatures
J. Heat Transfer (November,1994)
Numerical Investigation and Nondimensional Analysis of the Dynamic Performance of a Thermal Energy Storage System Containing Phase Change Materials and Liquid Water
J. Sol. Energy Eng (April,2017)
Turbulent Heat Transfer in Plane Couette Flow
J. Heat Transfer (January,2006)
Related Chapters
Natural Gas Transmission
Pipeline Design & Construction: A Practical Approach, Third Edition
Optimization of an Irregular 2D Packing Problem by a Genetic-Based Heuristic Algorithm
International Conference on Computer and Automation Engineering, 4th (ICCAE 2012)
The Thermo —Mechanical Analysis of Mechanical Packing (SEAL), Using Finite Element Method (FEM) — Results and Conclusions
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)