When machining miniaturized components, the contact conditions between the tool and workpiece exhibit very small contact areas that are on the order of 10−5 mm2. Under these conditions, extremely high contact stresses are generated and it is not clear whether macroscopic theories for the chip formation, cutting forces, and the friction mechanisms are applicable. For this reason, the present investigation has focused on creating a basic understanding of the frictional behavior in micro machining processes so that evaluations of standard macro-scale models could be performed. Specialized machining experiments were conducted on 70/30 brass materials using steel tools over a range of speeds, feeds, depths of cut and tool rake angles. At each operating condition studied, the friction coefficient and the shear factor, τk, were obtained. Based on the experimental results, it was determined that standard macroscopic theory for analyzing detailed friction mechanisms was insufficient in micro machining processes. An approach that utilized the shear factor, in contrast, was found to be better for decoupling the physical phenomena involved. Utilizing the shear factor as an analysis parameter, the parameters that significantly influence the friction in microscale machining process were ascertained and discussed.
- Tribology Division
On the Modeling of Friction in Micromachining Processes
- Views Icon Views
- Share Icon Share
- Search Site
Lovell, MR, Cohen, PH, & Shankar, R. "On the Modeling of Friction in Micromachining Processes." Proceedings of the ASME/STLE 2007 International Joint Tribology Conference. ASME/STLE 2007 International Joint Tribology Conference, Parts A and B. San Diego, California, USA. October 22–24, 2007. pp. 733-735. ASME. https://doi.org/10.1115/IJTC2007-44196
Download citation file: